Description
Your marker can fire thousands of rounds every week, puts up with the beating of countless rainy Sundays, and withstands a number of slides through the dirt and mud. Through all of this, you still expect your marker to perform week in and week out. A small bit of maintenance is key to ensuring that your marker functions and performs at its best.
One major aspect of marker maintenance is replacing your o-rings. The o-rings in your marker wear down over time by withstanding thousands of cycles along with coming in contact with dirt/debris. Our kits provide an easy and inexpensive way to keep your marker in top shape by swapping out your o-rings.
- O-rings are color coded by size, eliminating the headache of matching up sizes. An included color/size chart helps with your first time rebuilding your marker. After that, just replace o-rings by color when it comes time to rebuild again.
- All of the o-rings you need to perform a standard rebuild of your marker three times (other quantities available).
- Contains o-rings for your markers firing assembly, high pressure regulator, LPR (if applicable), etc (unless otherwise noted). Don't be fooled by other kits that only offer a fraction of the o-rings needed to rebuild your marker.
- Kit includes o-rings sorted by size in individual compartments, as well as a comprehensive o-ring placement list.
- 007 - Hyper 3 Reg Seat
- 007 - LPR Piston Small)
- 010 - Hyper 3 Seat Housing
- 010 - LPR Seal Retainer
- 011 - Hyper 3 Top Cap
- 011 - Inside Bolt Stem
- 011 - Rear Bolt Stem
- 012 (x2) - LPR Body
- 012 - LPR Piston (Large)
- 013 - Hyper 3 Swivel
- 014 - Bolt Tip
- 014 - Top Hat
- 015 - Bolt Sail
- 017 - Front Wall (Internal)
- 017 - Top Hat
- 020 (x5) - Outer Sleeve
- 111 - Front Bumper
- 111 - Rear Bumper